First Prints!

Now the build is almost complete and I can start using Voron to print remaining Voron parts :)

This is the very first print attempt. Some Z height adjustment errors.

Much better results after some tuning!

Looking quite good! Some ghosting or ringing can still be seeing.

I cancelled the print after some time as it was almost 2 AM :)

First real print. The model didn't stick to the bed for long enough.

Incorrect Z height, part cooling on, too much filament... So much errors still to fix.

And now we are printing Voron lower valance skirts!

Electronic Compartment

Initial layout of 230 volt section

Inserting wires into cable sock

All wires inserted to Z chain and sock

Most of the cabling done. Some cleaning up to do.

All wires have been tied and labeled